Gauge for iSUP Hand Pump pump-parts use the same pinching technique

use the same pinching technique and insert it into the hole of the middle shaft until it pops into place

At 12'6" x 6"

So get ready to hit the water and experience the ultimate paddleboarding journey with the Tower Adventurer 2

this package is hard to beat

this button may experience corrosion and rust if not washed and dried properly after each use

Gauge for iSUP Hand Pump pump-parts use the same pinching techniqueReplace your Tower iSUP hand pump gauge with our inflatable paddle board pump replacement gauge. This gauge is designed to be connected in line with the pump and the yellow hose for accurate pressure readings. It is important to note that this gauge is optimized for registering high PSI levels and may not register accurately at very low levels. It is recommended to inflate your board to at least 5 7 PSI before relying on the gauge for pressure