Air Injected Wedge mix-pour-foam How Should Rook Pattern Carbon

How Should Rook Pattern Carbon Fiber Be Used for Best Results

They are ambidextrous and come in both pre-powdered and powder-free for easy slide onto either hand

Proper fabrication requires vacuum bagging and oven curing

All three rollers are approximately one foot in total length

Nylon permits use with high temperature range

Air Injected Wedge mix-pour-foam How Should Rook Pattern CarbonExperienced fabricators will likely run across that hard to separate part, whether it's larger in nature or just stubbornwhich presents a challenge for demolding. Standard wedges only reach a few inches into any mold, and using force can result in damage. Applied air pressure provides a solution. Our #958 Air Injected Wedge is designed to deliver air all the way to the sticking point to provide pressure where it is needed most. Simply insert the wedge